Toro 25500 Operator's Manual page 28

Note: If the indicator goes into the red area, reduce
the engine speed to idle for a few minutes to allow the
engine to cool, then stop the engine. Check the coolant
level, for debris on the radiator, or for a thermostat that
does not operate correctly. Also check the drive belt, belt
tensioner, or water-pump pulley.
•
Fuel-level indicator—This indicator shows the
remaining level of fuel that is in the tank, and it is
displayed in the lower right area of the command display
(Figure 31).
•
Parking-brake-on indicator—This indicator is
displayed while the parking brake is engaged
The indicator disappears when you release the parking
brake.
Changing Units of Measure
Use this procedure to change from English to metric units or
from metric to English units
1. Display the home screen of the command center
(Figure 32).
1. Left+right+up buttons
2. Press the left+right+up buttons
Note: The units of measure should change from
English to metric units or from metric to English units.
Note: If the display changes from the home screen to
the main selection screen, press the left, right, up, or
down button to return to the home screen.
Reading the Warning Messages in the Command
Display
Note: When there are warning messages in the command
display, take corrective measures immediately. There may be
more than 1 warning displayed.
(Figure
Figure 32
(Figure 32).
31).
1. Machine or engine error
2. Low engine-oil pressure
(flashes)
3. High hydraulic-oil
temperature (flashes)
•
Machine or engine error—This message displays if the
machine or engine experiences a fault. The cause of the
fault is given in the Instrument Panel Diagnostics
33).
Important: Do not run the engine if this warning
message appears.
•
Low engine-oil pressure—This warning message
displays if the oil pressure of the engine is 90 Kpa (13 psi)
or lower (Figure 31
Important: Do not run the engine if this warning
message appears.
•
High hydraulic-oil temperature—This message flashes
if the oil in the hydraulic system is 102° C (215° F) or
higher (Figure
Important: Do not run the engine if this warning
message appears.
•
Check alternator or battery—This message displays
if the alternator and battery voltage is 12 volts or less
(Figure 31 and
Note: If this message is appears, stop the engine, repair
the charging system, or replace the battery.
•
Engine overheated—This message flashes if the engine
coolant is 104° C (220° F) or higher
33).
Important: Do not run the engine if this warning
message appears.
•
Low fuel quantity—This message displays when the fuel
quantity in the tank is less than 18.2 L (5.8 US gal).
•
Wait-to-start-engine indicator—This indicator displays
when the key switch is in the On position and the intake
air heater for the engine is energized
Note: Wait until the indicator no longer appears before
attempting to start the engine
28
Figure 33
4. Check alternator or battery
5. Engine overheated
(flashes)
6. Low fuel quantity (flashes)
and Figure 33).
33)
Figure 33).
(Figure 31
(Figure
(Figure 34).
(Figure
and Figure
34).