Table of Contents
Advertisement
Installing the Side Panels
1. Align the side panel with the machine frame.
2. Align the mounting bolt at the top of the side panel
with the hole in the support flange of the hood panel
(Figure
61).
Figure 61
1. Hole (support
flange—hood panel)
2. Mounting bolt
3. Apply light inward pressure against the panel at 1 of
the latches.
4. Set the latch by pushing in the latch lever
5. Repeat steps
3
and
6. If the backhoe is installed on the machine, do the
following substeps:
A. Rotate the front end of the walkway to its original
position
(Figure
B. Align the hole in the walkway with the hole in the
walkway support bracket
C. Install the retaining pin through the holes.
3. Hood panel
4. Side panel
(Figure
4
at the other latch.
58).
(Figure
58).
Servicing the Engine Oil and
Filter
Crankcase capacity: 15.0 L (15.9 US qt) with the filter.
Use only high-quality SAE 15W-40 heavy-duty engine oil with
an API classification of CH-4 or higher.
While SAE 15W-40 oil with an API classification of CH-4 or
higher is recommended for most climates, refer to
for oil viscosity recommendations for extreme climates.
All Seasons
Winter Conditions
Arctic Conditions
G022415
Note: Limited use of low-viscosity oils such as SAE 10W-30
with an API classification of CH-4 or higher can be used for
easier starting and providing sufficient oil flow at ambient
59).
temperatures below -5°C (23°F). However, continuous use of
low viscosity oil can decrease engine life because of wear.
Toro Premium Engine Oil is available from an Authorized
Toro Service Dealer in either 15W-40 or 10W-30 viscosity
with API classification CH-4 or higher. See the Parts Catalog
for part numbers. Also, refer to the Engine Operator's Manual,
included with the machine, for further recommendations.
Changing the Engine Oil and Filter
Service Interval: Every 500 hours
Draining the Engine Oil
1. Run the engine until the water temperature reaches
60°C (140°F).
Note: Warm oil drains better and carries more
contaminants.
2. Stop the engine.
3. Remove the right side panel; refer to
Side Panels (page
4. Place a drain pan that has a minimum capacity of 20 L
(21 US qt) under the engine-oil drain fitting
45
°C
-40 -30 -20 -10 0
10 20 30 40 50
°C
-40 -22 -2 14 32 50 58 86 104 122
15W-40
10W-30
5W-30
°C
-40 -30 -20 -10 0
10 20 30 40 50
°C
-40 -22 -2 14 32 50 58 86 104 122
Figure 62
Removing the
44).
Figure 62
(Figure
63).
Advertisement
Table of Contents
