Table of Contents
Advertisement
Cleaning the Axle Breathers
Service Interval: Every 1,000 hours
1. Clean the area around the breathers with a cleaning
solvent
(Figure 91
and
Figure 91
1. Breather fitting
Figure 92
1. Breather fitting
2. Remove the breathers from the front axle and rear
axles
(Figure 91
and
3. Clean the breathers with a cleaning solvent.
4. Use compressed air to dry the breathers.
Important: Wear face protection when using
compressed air.
5. Install the breathers into the front and rear
91
and
Figure
92).
Figure
92).
2. Front axle
2. Rear axle
Figure
92).
axles(Figure
Servicing the Transmission
Transmission-oil specification: Mobilfluid 424
Checking the Oil Level in the
Transmission
Service Interval: Every 100 hours
Important: If you operate the machine while the level of
the transmission oil is below the recommended level, you
may damage the transmission and the parking brake.
1. Park the machine on a level surface.
2. Start the engine and run it for 10 minutes.
3. Stop the engine and remove the ignition key.
4. After 5 minutes, check the transmission oil level in the
sight gauge
(Figure
Note: The oil level should cover 1/2 to 3/4 of the
sight-gauge window.
1. Sight gauge
5. If the oil level is low, add the specified oil into the
transmission; refer to
(page
61).
6. Repeat steps
2
through
to 3/4 of the sight-gauge window
Note: As you add oil to the transmission, perform
steps
2
through
60
93).
Figure 93
Filling the Transmission with Oil
5
until the oil level covers 1/2
(Figure
4
to determine the corrected oil level.
93).
Advertisement
Table of Contents
