Servicing The Axles - Toro 25500 Operator's Manual

Figure 82
B. Torque all the nuts to 200 N-m (150 ft-lb) in the
sequence shown in Figure
C. Torque all the nuts to 300 N-m (225 ft-lb) in the
sequence shown in Figure
82.
82.
56

Servicing the Axles

Hub-and-axle oil specification: Mobilfluid 424
Checking the Oil Level in the Wheel
Hubs
Service Interval: After the first 100 hours
Every 250 hours
Note: Have another person help you align the oil plugs in
the axles when you service the axle oil.
1. Ensure that the machine is on a level surface and that
all the attachments are in the transport position.
2. Move the machine forward or backward until the plug
for the wheel hub is at either the 3 o'clock or 9 o'clock
position (Figure 83).
1. Wheel hub
2. Oil port at the 9 o'clock
position
3. Plug
3. Stop the engine, set the parking brake, and remove the
ignition key.
4. Place a drain pan under the drain port in the wheel hub
(Figure 83).
5. Remove the plug from the wheel hub
6. Check that the oil level is at the bottom of the threads
of the oil port (Figure
•
If the oil level is too high, allow the oil to drain
from the oil port.
•
If the oil level is too low, add the specified oil to the
wheel hub through the oil port; refer to step
Changing the Oil in the Wheel Hubs (page
7. Check the condition of the O-ring on the plug.
Note: Replace the O-ring if it is worn or damaged.
8. Install the plug in the oil port of the wheel hub
83).
9. Repeat steps 2 through
Figure 83
4. Drain pan
5. Oil port at the 3 o'clock
position (alternative)
(Figure
83).
8 for the other wheel hubs.
83).
6 in
57).
(Figure