Toro 25500 Operator's Manual page 43

Figure 55
Rear axle
1. Grease fitting (upper pivot) 2. Grease fitting (lower pivot)
3. Connect the grease gun to the grease fittings for the
forward- and rear-axle tilt pivots; apply 2 or 3 pumps
of grease to each fitting
Figure 56
1. Grease fittings (4)
4. Wipe up any excess grease.
(Figure 56).
Greasing the Front and Rear Drive
Shafts
Service Interval: Every 500 hours
1. Clean the grease fittings with a rag.
2. Connect the grease gun to the grease fitting for the
slide coupling at the forward end of the drive shaft, and
apply 2 or 3 pumps of grease to the fitting
1. Grease fitting (back
universal joint)
3. Connect the grease gun to the grease fitting for the
universal joint at the forward end of the drive shaft, and
apply 2 or 3 pumps of grease to the fitting
4. Connect the grease gun to the grease fitting for the
universal joint at the back end of the drive shaft, and
apply 2 or 3 pumps of grease to the fitting
5. Wipe up any excess grease.
43
(Figure
Figure 57
2. Grease fitting (forward
universal joint)
(Figure
(Figure
57).
57).
57).