Checking The Interlock Switches; Using The Rollover Protection System (Rops) - Toro 30605 Operator's Manual

Allows the operator to adjust the maximum transport
speed (high range) of the machine, within the supervisors
pre-adjusted settings. When in the InfoCenter splash or
main screen, press the middle button (
the speed.
Note: When switching between low and high ranges, the
settings transfer based on the previous setting. The settings
are reset when the machine is turned off.
Note: This feature may also be used in conjunction with
cruise control.
Checking the Interlock
Switches
CAUTION
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
The machine has interlock switches in the electrical system.
These switches are designed to stop traction when the
operator gets off of the seat when the traction pedal is
pressed. Although the engine will continue to run, stop the
engine before rising from the seat.
1. Drive the machine slowly to a large, relatively open
area. Lower the cutting unit, stop the engine, and apply
the parking brake.
2. Sit on the seat and press the traction pedal. Try to start
the engine; the engine should not crank. If the engine
cranks, there is a malfunction in the interlock system
that should be corrected before beginning operation.
3. Sit on the seat and start the engine. Rise from the seat
and move the PTO lever to On; the PTO should not
engage. If the PTO engages, there is a malfunction in
the interlock system that should be corrected before
beginning operation.
4. Sit on the seat, engage the parking brake, and start the
engine. Move the traction pedal out of the
position. The InfoCenter should display "traction
not allowed" and the machine should not move. If
the engine does move, there is a malfunction in the
interlock system that should be corrected before
beginning operation.
Using the Rollover Protection
System (ROPS)
icon) to adjust
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the seat is secured with the seat latch.
There is no rollover protection when the roll bar is
in the down position.
• Do not operate the machine on uneven ground
or on a hill side with the ROPS in the down
position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when absolutely
necessary.
1. To lower the roll bar, remove the hairpin cotters and
NEUTRAL
1. Pin (2)
2. Lower the roll bar to the down position.
3. Install the 2 pins and secure them with the hairpin
32
WARNING
WARNING
the 2 pins (Figure 29).
Figure 29
cotter pins.
2. Hairpin cotter (2)