Toro 30605 Operator's Manual page 38

g017810
Front-Lift Assemblies
•
Lift-arm-cylinder bushings (2 each)
•
Lift-arm ball joints (2)
Side Cutting Units
•
Castor-fork-shaft bushing (1)
•
Spindle-shaft bearings (2 each)
Note: These bearings are located under the pulley.
•
Idler-arm-pivot bushing (1)
Note: This bushing is located on the idler arm.
Figure 37
(Figure 38)
(Figure 39)
Figure 38
Figure 39
(Figure 40)
Side-Lift Assemblies
•
Main-lift-arm bushings (6)
•
Bell-crank-pivot bushings (2)
•
Rear-arm bushings (4)
•
Lift-cylinder bushings (4)
38
Figure 40
(Figure 41 and Figure
(Figure 43)
(Figure 43)
(Figure 44)
Figure 41
Figure 42
42)