Changing The Rear Axle Lubricant; Checking The Rear Wheel Toe-In - Toro 30605 Operator's Manual

Changing the Rear Axle
Lubricant
Service Interval: After the first 200 hours
Every 800 hours
1. Move the machine onto a level surface.
2. Clean the area around the 3 drain plugs; 1 on each end
and 1 in the center
3. Remove the check plugs to ease in draining of the oil.
4. Remove the drain plugs and allow the oil to drain into
the pans.
1. Drain plug
5. Clean the area around the drain plug on the bottom
of the gearbox (Figure
1. Drain plug
6. Remove the drain plug from the gearbox and allow the
oil to drain into a pan.
7. Remove the fill plug to ease in draining of the oil.
(Figure 59).
Figure 59
60).
Figure 60
8. Add enough oil to bring the level up to the bottom of
the check plug holes; refer to
and Filter (page
9. Install the plugs.
Checking the Rear Wheel
Toe-in
Service Interval: Every 800 hours
1. Measure the center-to-center distance (at axle height) at
the front and the rear of the steering tires.
Note: The front measurement must be 6 mm (1/4
inch) less than the rear measurement.
2. Loosen the clamps at both ends of the tie rods.
3. Rotate the tie-rod end to move the front of the tire
inward or outward.
4. Tighten the tie-rod clamps when the adjustment is
correct.
45
Servicing the Engine Oil
40).