UNIVERGE SV8100
System Hardware Manual
2.7.4.1
Connector Pin-Out on the PZ-BS10/PZ-BS11
Table 3-1 PZ-BS10/PZ-BS11 Connector Pin-Out
PZ-BS10 – CN2, CN3, CN 4
2.7.4.2
Install the PZ-BS10 Expansion Base Blade in the CHS2U
Controlling Chassis
1.
Ensure the chassis is powered down.
2.
Locate the door positioned on the left end
(expansion bay) of the Controlling Chassis.
Figure 3-48 PZ-BS10 Expansion Bay in Controlling Chassis
RJ-61 Cable Connector
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with
the power on.
Expansion Bay
Issue 5.0
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)
3 - 43