UNIVERGE SV8100
R
S
4
EMOVE AND
ECTION
If required, the cooling fan installed in the CHS2U chassis can be removed and
replaced. The following provides the procedure for the CHS2U chassis.
4.1
System Hardware Manual
I
NSTALL
CHS2U Chassis
4.1.1
Remove Cooling Fan
To reduce the possibility of electrical shock or
damage to equipment, NEC recommends
powering Off the chassis and disconnecting the
AC cable from the power source before
removing the chassis cover.
1.
Ensure the chassis is powered down.
2.
Loosen retaining screw from chassis access panel.
C
F
OOLING
AN
To reduce the possibility of damage to
equipment, the installer must wear a
grounded wrist strap to protect the
equipment from static electricity.
Figure 3-101 19" Chassis Access Panel
Issue 5.0
Retaining Screw
3 - 77