Performing A Software Upgrade - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
After reloading the customer data to the system, exit
programming mode (this could take a minute or more to
save the database), then reset the system by powering
down and back up. If the system is not reset, not all the
uploaded programming changes are in effect. Wait a few
minutes for the programming to take affect before accessing
any line or special system feature. Otherwise, some unusual
LED indications may be experienced. To prevent the USB
Memory from possibly being overwritten, remove the card
after reloading the database.
2.6.4

Performing a Software Upgrade

This section describes the procedure to perform a software upgrade
on the CD-CP00.
Issue 5.0
4 - 13