Check Transaxle / Hydraulic Fluid; Check Front Differential Oil - Toro 07360 Operator's Manual

Caution
If the engine has been running, the pressurized,
hot coolant can escape and cause burns.
• Do not open the radiator cap when the engine is
running.
• Allow engine to cool at least 15 minutes or until
the radiator cap is cool enough to touch without
burning hand.
• Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
2. Check coolant level. Coolant should be up to COLD
line on reserve tank, when engine is cold.
3
2
Figure 17
1. Reserve tank
2. Cold line
3. If coolant is low, remove reserve tank cap and add a
50/50 mixture of water and permanent ethylene glycol
anti–freeze. DO NOT OVERFILL.
4. Install reserve tank cap.
Check Transaxle / Hydraulic
Fluid
The transaxle reservoir is filled with Dexron IIl ATF. Check
level before engine is first started and every 8 hours or
daily, thereafter. Capacity of system is 7.5 qt.
1. Position the vehicle on a level surface.
2. Clean area around dipstick.
3. Unscrew dipstick from top of transaxle and wipe it with
a clean rag.
1
3. Hot line
22
Figure 18
1. Dipstick
4. Screw dipstick into transaxle and make sure it is seated
fully. Unscrew dipstick and check fluid level. Fluid
should be up to top of flat portion of dipstick. If level is
low, add enough fluid to achieve the proper level.

Check Front Differential Oil

Four wheel drive only
The differential is filled with 10W30 oil. Check level of oil
every 100 hours or monthly. Capacity of system is 1 qt.
1. Position the vehicle on a level surface.
2. Clean area around fill/check plug on side of differential.
3. Remove fill/check plug and check level of oil. Oil
should be up to hole. If oil is low, add 10W30 oil.
4. Re–install fill/check plug.
3
Figure 19
1. Front differential
2. Fill/check plug
1
1
2
3. Drain plug