Adjusting Parking Brake; Adjusting Shift Cables - Toro 07360 Operator's Manual

7. Recheck the clutch safety switch adjustment (Fig. 65).
The engine must not crank unless clutch pedal is
1.25" ±.12" from floor. If an adjustment is required,
loosen switch jam nuts and adjust up or down.
Figure 65
1. Clutch switch

Adjusting Parking Brake

Check adjustment every 200 hours.
1. Remove rubber grip from parking brake lever (Fig. 66)
1
Figure 66
1. Parking brake lever
2. Loosen set screw securing knob to parking brake lever
(Fig. 67).
3. Rotate knob until a force of 30–40 lbs. is required to
actuate lever.
1
2
2. Grip
1. Parking brake lever
2. Knob
4. Tighten set screw after adjustment has been attained.
5. Install rubber grip onto parking brake lever.

Adjusting Shift Cables

Check adjustment every 200 hours.
1. Move shift lever to Neutral position.
2. Remove clevis pins securing shift cables to transaxle
shift arms.
2
3
1. Shift arm (1st – Rev.)
2. Shift arm (2nd – 3rd)
3. Loosen clevis jam nuts and adjust each clevis so cable
free play is equal forward and backward relative to hole
in transaxle shift arm (With transaxle lever free play
taken up in same direction).
4. Reinstall clevis pins and tighten jam nuts after
adjustments have been attained.
48
1
3
Figure 67
3. Set screw
1
Figure 68
3. Shift arm (High–low)
2