Adjusting Clutch Pedal - Toro 07360 Operator's Manual

4. Adjust yoke until its holes align with hole in brake
pedal pivot. Secure yoke to pedal pivot with clevis pin
and cotter pin.
5. Tighten jam nuts securing yoke to master cylinder shaft.
Note: The brake master cylinder must relieve pressure
when properly adjusted.
2
Figure 61
1. Brake pedal

Adjusting Clutch Pedal

Check adjustment every 200 hours.
Note: The clutch pedal cable can be adjusted at the bell
housing or at the clutch pedal pivot. The front hood can be
removed to ease the access to pedal pivot.
1. Loosen the jam nuts securing the clutch cable to the
bracket on the bell housing (Fig. 62).
4
3
Figure 62
1. Clutch cable
2. Jam nuts
Note: The ball joint may be removed and rotated, if
additional adjustment is required.
2. Disconnect the return spring from the clutch lever.
1
2. Clutch pedal
1
2
3. Return spring
4. Ball joint
47
3. Adjust the jam nuts/or ball joint until the back rear edge
of the clutch pedal is 3.75" + .12" from the top of the
floor plate diamond pattern, when an 4 lb. force is
applied to the pedal (Fig. 63).
3.75 + .12"
Figure 63
1. Clutch pedal
Note: Force is applied so the clutch release bearing lightly
contacts pressure plate fingers.
4. Tighten the jam nuts after the adjustment has been
attained.
5. Recheck the 3.75" + .12" dimension after the jam nuts
have been tightened to ensure proper adjustment.
Readjust, if necessary.
6. Reconnect the return spring to the clutch lever.
Important Make sure the rod end is positioned
squarely on the ball, not twisted, and remains parallel to the
clutch pedal after the jam nut is tightened (Fig. 64).
2
4
Figure 64
1. Clutch cable rod end
2. Clutch pedal
Note: The clutch free play should never be less than .75".
1
1
3
3. Rod end jam nut
4. Parallel