Adjusting High-Low Cable; Adjusting Differential Lock Cable; Inspect Brakes; Inspect Tires - Toro 07360 Operator's Manual

Adjusting High–low Cable
Check adjustment every 200 hours.
1. Remove clevis pin securing High–Low cable to
transaxle.
2. Loosen clevis jam nut and adjust clevis so clevis hole
aligns with hole in transaxle bracket.
3. Reinstall clevis pin and tighten jam nut after adjustment
has been attained.
Adjusting Differential Lock
Cable
Check adjustment every 200 hours.
1. Move differential lock lever to Off position.
2. Loosen jam nuts securing differential lock cable to
bracket on transaxle.
2
3
Figure 69
1. Differential lock cable
2. Transaxle bracket
3. Adjust jam nuts to obtain .035" ± .025" gap between
spring hook and O.D. of hole in transaxle lever.
4. Tighten jam nuts after adjustment has been attained.

Inspect Brakes

Visually inspect brakes for worn brake shoes after every
400 hours of operation.
1
.035" + .025"
3. Spring
49

Inspect Tires

Check tire condition at least every 200 hours of operation.
Operating accidents, such as hitting curbs, can damage a
tire or rim and also disrupt wheel alignment, so inspect tire
condition after an accident.

Front Wheel Toe

After every 400 operating hours or annually, check front
wheel toe–out.
1. Measure center–to–center distance (at axle height) at
front and rear of steering tires. The measurement must
be .12 $ .12" greater at the front of the tire than at the
rear.
Front of Vehicle
.12 + .12"
Greater than rear of tire
Center–to–center
Distance
Figure 70
2. Adjust the center–to–center distance as follows:
• On the right front wheel, loosen the jam nuts at both
ends of the tie rod (Fig. 71).
Figure 71
1. Tie rod
• On the left front wheel, loosen the jam nuts at both
ends of the turnbuckle (Fig. 72).
• Rotate the tie rod and turnbuckle evenly to move the
front of the tire inward or outward to achieve the
center to center distances from front to back.
• Tighten tie rod and turnbuckle jam nuts when the
adjustment is correct.
1