Fuses; Jump Starting Procedure - Toro 07360 Operator's Manual

• On the other vehicle, connect the two hoses to the
coupler still in the coupler bracket (Connect the top
hose to the top coupler and the bottom hose to the
bottom coupler. Cap unused fittings.
1
Figure 75
1. Jumper hoses
• Keep all bystanders away from the vehicles.
• Start second vehicle and move lift lever to the raise
position which will raise the disabled box.
• Move the hydraulic lift lever to the neutral position and
engage the lift lever lock.
• Install the bed safety support onto the extended lift
cylinder. Refer to Using the Bed Safety Support.
Note: With both the vehicles turned off, move the lift lever
back and forth to remove the system pressure and ease the
disconnection of the quick couplers.
• After completing operation, remove jumper hoses and
connect hydraulic hoses to both vehicles.
Important Check hydraulic fluid levels, in both
vehicles, before resuming operation.

Fuses

The fuses for the machine's electrical system are located
under the center of the dash panel.
1
1. Fuses

Jump Starting Procedure

Warning
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in
vehicle, observe the following warnings:
• Never jump start with a voltage sources greater
than 15 volts D.C. This will damage the
electrical system.
• Never attempt to jump start a discharged
battery that is frozen. It could rupture or
explode during jump starting.
• Observe all battery warnings while jump
starting your vehicle.
• Be sure your vehicle is not touching the jump
start vehicle.
• Connecting cables to the wrong post could result
in personal injury and/or damage to the
electrical system.
51
Figure 76
Figure 77