Enabling The Alarm - Silvercrest SWE 100 A1 User Manual And Service Information

Enabling the Alarm

After the desired alarm time has been set, you can enable the
alarm as follows:
 Press
the
"ALARM" [28] appears on the display.
 To disable the alarm, press the AL.ON/OFF button [13]
again. The indication "ALARM" [28] disappears.
 The device will power on at the set alarm time and will
receive the last tuned-in frequency and frequency band.
 Press the On/Off button [7] to switch the device off;
 or
 press the SNOOZE button [10] to delay the alarm for approx.
5 minutes. After this delay, the device will power on again.
AL.ON/OFF
Even when the alarm function is enabled, you
can use the
remember that the device always powers on with
the last tuned-in frequency and frequency band
as well as the last volume setting.
The alarm function will work only if the device
has been powered off previously.
Multi-Band Tuner SWE 100 A1
button [13].
device as
The indication
usual. However,
English - 19