Table of Contents
Advertisement
Configuration
40
Siemens AG
You can adjust the minimum number of detection blocks that must be activated to
trigger a motion alarm. Highlighting the box under the Min. Blocks heading and
pressing the
button allow you to adjust the minimum number of detection blocks
for Daytime and Nighttime independently. Smaller numbers provide greater
sensitivity because fewer detection blocks must be activated.
Fig. 32
Motion Detection Min. Blocks screen
Turning Zone View On will allow you to observe how the DVR is reacting to motion.
When in the motion viewing mode, the detection zone of video will be displayed in
green. Any detected motion within the zone will be displayed in red.
You can define the area of the image where you want to detect motion; e.g., a
doorway. Highlight the box under the Zone heading, and press the
Î
The Motion Detection Zone screen displays.
Fig. 33
Motion Detection Zone screen
The Motion Detection Zone screen is laid over the video for the selected camera.
You can set up motion detection zones by selecting or clearing blocks.
NOTE
You can set up motion zones one block at a time in groups of 4 individual block groups. A block group
is positioned within the image area using the Up and Down arrow buttons, and individual blocks within
the block groups are selected or cleared using the camera buttons.
Press the
button to display the menu screen. The menu on the setup screen has
the following functions:
button.
06.2010
Hide quick links:
Advertisement
Table of Contents
