D-Link DWC-2000 Cli Reference Manual page 23

show security
1
advanced_network
show security
2
advanced_network igmp
The command "show ldap-serverCheck ?" at the CLI prompt, gives a
description of all the show commands in the branch ldap-serverCheck , these
are as follows:
1 show ldap-serverCheck
The command "show net ?" at the CLI prompt, gives a description of all the
show commands in the branch net , these are as follows:
1 show net bandwidth
2 show net bandwidth profile
show net bandwidth profile
3
setup
show net bandwidth
4
traffic_selector
show net bandwidth
5
traffic_selector setup
6 show net lan dhcp
7 show net lan dhcp reserved_ip .
show net lan dhcp reserved_ip
8
setup
show net lan dhcp
9
leased_clients
show net lan dhcp
10
leased_clients list
11 show net ethernet
12 show net lan
13 show net lan ipv4
14 show net lan ipv4 setup
15 show net lan ipv6
16 show net lan ipv6 setup
17 show net statistics <interface> Show Interface Statistics.
18 show net mode
19 show net mode setup
20 show net port
21 show net port management
22 show net port management
show advanced firewall
attack checks.
Display igmp configuration.
Display status of Ldap servers.
.
.
Show list of Available
Bandwidth Profile(s).
.
Show list of Available
Traffic Selector(s).
.
Show list of DHCP
Reserved Addresses.
.
Show list of Available
DHCP Leased Clients.
Show Ethernet interfaces.
.
.
Show LAN Configuration.
.
Show LAN Configuration.
.
Display IP MODE
configuration.
.
.
Display port management
21