Net Radvd Configure - D-Link DWC-2000 Cli Reference Manual

1 <portName>
2 save
3 exit
4 cancel
5 enable
6 auto_negotiation_enable
7 duplex_mode
8 speed

7.18 net radvd configure

S.No Command Name Description
1 save
2 exit
3 cancel
4 enable
5 mode
6 interval
7 flags
flags
8
managed_enable
flags
9
other_enable
Port management configuration mode.
Saves port management configuration
changes.
Saves port management configuration
changes and exits current mode.
Rolls back port management configuration
changes.
Enables/Disables the port status.
Allows the gateway and network to
determine the optimal port settings.
Choose between Half Duplex and Full
Duplex based on the port support. The
default is Full Duplex for all ports.
One of three port speeds can be selected:
10 Mbps, 100 Mbps and 1000 Mbps (i.e. 1
Gbps). The default setting is 1000 Mbps
for all ports.
Saves radvd configuration changes.
Saves radvd configuration changes and exits
current mode.
Rolls back radvd configuration changes.
Enables the radvd process to allow stateless
auto configuration of the IPv6 LAN network.
Selects N to send router advertisements
(RA's) to all interfaces else Y
The time in seconds between sending
unsolicited multicast RA's. The default is 30
seconds.
RA Flags.
Enable to use the administered/stateful
protocol for address auto configuration.
When the other flag is selected the host uses
administered/stateful protocol of other (i.e.
97
Description
Port name.
Boolean
choice.
Boolean
choice
select the
duplex mode
select the
speed
Type and
Description
Boolean choice
radvd
advertisement
mode type.
PPPOE idle
timeout Type.
Boolean choice.
Boolean choice.