D-Link AC3200 Ultra User Manual page 41

Section 4 - Configuration - Router Mode
Select Static IP if your IP information is provided by your Internet Service Provider (ISP).
Device Mode: Router Mode
My Internet Static IP
Connection Is:
IP Address:
Enter the IP address provided by your ISP.
Subnet Mask: Enter the subnet mask provided by your ISP.
Default Gateway: Enter the default gateway address provided by your ISP.
Primary DNS Enter the primary DNS server IP address assigned by your ISP.
Server:
Advanced Settings
Secondary DNS
Enter the secondary DNS server IP address assigned by your ISP.
Server:
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
MAC Address
The default MAC address is set to the Internet port's physical interface
Clone: MAC address on the router. You can use the drop-down menu to
replace the Internet port's MAC address with the MAC address of a
connected client.
For more information on enabling the VLAN feature, refer to VLAN
VLAN:
Bridging on page 45.
Click Save when you are done.
D-Link DIR-890L User Manual
Static IP
DIR-890L HW:A1
Settings >> Internet
Home Settings
FW:1.10
Internet
Use this section to configure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
⌵
Device Mode: Router Mode
⌵
My Internet Connection is: Static IP
IP Address:
Subnet Mask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server:
⌵
MTU: Auto
Mac Address Clone:
VLAN: Disabled
COPYRIGHT © 2016 D-Link
Features Management
IPv6 Save
Advanced Settings ...
⌵
<< MAC Address
36