Table of Contents
Advertisement
Chapter 2 Preparations
106
• SAS Hard Disk Drives and SATA Hard Disk Drives cannot be combined.
Important
• About RAID LED cables
The DISK access LED on the front of the equipment shows the access status of
Hard Disk Drives that are connected to a RAID Controller. To display this status,
connect the LED cable provided with the optional K cord cable K410-253(00).
Connect the LED connector on the motherboard to the connector on the RAID
Controller.
Refer to the figures below and connect the LED cable to the LED connector of the
motherboard.
Connect the opposite end of the cable to connect to the RAID Controller.
RAID Controller N8103-129/130
Express5800/GT110d-S User's Guide
Mottherboard
RAID Controller N8103-128/134
Red
Black
1. Installing Internal Optional Devices
To the motherboard side
LED connector
Black
Red
Advertisement
Table of Contents
