NEC Express5800/GT110d-S (2C/i3-2120) EXP281A User Manual page 108

Chapter 2 Preparations
(When 5 Hard Disk Drives are installed)
RAID Controller
(N8103-128/129/130/134)
•
If connecting a SATA Hard Disk Drive or solid state drive to an onboard SATA controller
To connect a SATA Hard Disk Drive or solid state drive (hereinafter referred to as Hard Disk Drive) to
the SATA controller, the dedicated cable K410-241(00) is required. Connect cables as instructed in the
image below. Match the number on the SATA connector of the cable with the SATA connector number
on the motherboard. Also connect the cable to the SGPIO connector on the motherboard.
Install Hard Disk Drives from Slot 0 in ascending order.
108
Power
supply
unit
Motherboard
Internal SATA cable (K410-180(00))
Battery cable (attached to the expansion battery)
SATA cable (for use with the optical disk drive)
MB SASBP signal cable (attached to the 2.5-inch expansion
HDD cage)
SATA cable (attached to the 2.5-inch expansion HDD
cage)
Tips • N8154-37 2.5-inch HDD cage for additional drives cannot be installed in water-cooled
models.
• LED cables attached to the K410-180(00) are not used.
Express5800/GT110d-S User's Guide
1. Installing Internal Optional Devices
Slot 2: Third Hard Disk Drive
Slot 1: Second Hard Disk Drive
Slot 0: First Hard Disk Drive
Optical disk drive
Extra battery (N8103-121/141)
2.5-inch expansion HDD cage
Slot 5: Fifth Hard Disk Drive
Slot 4: Fourth Hard Disk Drive