Table of Contents
Advertisement
Chapter 2 Preparations
1.7.4
Removal
Remove a DIMM in the following procedure.
1.
Refer to steps 1 to 5 in Chapter 2 (1.3 Overview of Installation and Removal for preparations.
2.
Rotate both levers of the target DIMM
slot outward.
The DIMM is unlocked
3.
Remove the DIMM by pulling it out from
the slot in a straight direction.
4.
Assemble the server.
5.
Turn on the server and confirm that no error messages are displayed on POST. If any error message
is displayed, refer to Chapter 3 (1. Post Error Message) in "Maintenance Guide".
6.
If you replaced a broken DIMM, select Yes in Memory Configuration-Memory Retest of the
Advanced menu.
After that, select Save Changes and Exit to reboot.
7.
Set the paging file size to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to Chapter 1 (7.1 Specifying Memory Dump Settings (Debug
Information)) in "Installation Guide (Windows)".
For other OS, consult the manual provided with the operation system or contact the store where you
purchased it or your maintenance service company.
Note
• When removing a defective DIMM, check error messages displayed at POST or
ESMPRO and check the DIMM slot where the defective DIMM is installed.
• At least one DIMM needs to be installed for the server to operate.
Important Applying too much pressure on a DIMM or pulling a DIMM at an angle
may break the DIMM or slot. Gently pull it straight out of the slot.
Express5800/GT110d-S User's Guide
1. Installing Internal Optional Devices
53
Advertisement
Table of Contents
