Table of Contents
Advertisement
Chapter 2 Preparations
1.9.3
Installing N8103-141 extra battery
Install an extra battery in the server by using the following procedure.
Filling out the date on the Set up date label
Write down n the installation date (year and month) on the Set up date label supplied with the extra
battery. Attach the label on the battery cover or somewhere easy to find on the server.
Fill out the Set up date label supplied with the battery
Installing the battery in the server
This section describes how to install an extra battery in the server. Note that the installation position
and procedure differ for 2.5-inch Hard Disk Drive models and 3.5-inch Hard Disk Drive models.
Getting ready to install the battery
(1)
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
(2)
While referring to Chapter 2 (1.4 Removing the Side Cover and 1.5 Removing the Front Bezel,
remove the side cover and front bezel.
(3)
If a RAID Controller is installed, remove the center bar to disconnect the internal SAS cable and
remove the RAID Controller. For details, refer to Chapter 2 (1.10 PCI Card).
70
Note
Read through the user's guide supplied with the RAID Controller before
installation.
Important
The shelf life of the battery pack is about 2 years though actual life depends
on the operating environment and conditions. If it has been used for 2 years
or more, the maximum data backup time (72 hours) is not guaranteed.
Replace it soon with a new battery pack, referring to the user's guide for the
extra battery.
Preparation for installation
Installing the connector board
Mounting the RAID Controller
Connecting the battery control remote cable
Installing the battery pack
in the 2.5-inch Hard Disk Drive model
Express5800/GT110d-S User's Guide
1. Installing Internal Optional Devices
Write the date.
Write the date
Example: Y 2007. M 12
Ex.:
Start
Installing the battery pack
in the 3.5-inch Hard Disk Drive model
Finish
Advertisement
Table of Contents
