Assembly And Installation - ABB i-bus KNX Product Manual


ABB i-bus KNX
Device Technology
2.4

Assembly and installation

The ABB i-bus
installation in the distribution board on 35 mm mounting rails to EN 60 715.
The mounting position can be selected as required.
The electrical connection is implemented using screw terminals. The connection to the bus is implemented
using the supplied bus connection terminal. The terminal assignment is located on the housing.
The device is ready for operation after connection to the bus voltage. If bus voltage is not yet available at
the time of commissioning, the device can be supplied with power for operation of the manual buttons
using the Power Supply NTI/Z.
Accessibility to the device for the purpose of operation, testing, visual inspection, maintenance and repair
must be provided compliant to VDE 0100-520.
Commissioning requirements
In order to commission the device, a PC with ETS and a KNX interface, e.g. USB or IP, are required. The
device is ready for operation after connection to the bus voltage.
The installation and commissioning may only be carried out by qualified electrical specialists. The
appropriate norms, guidelines, regulations and specifications for your country should be observed when
planning and setting up electrical installations and security systems for intrusion and fire detection.
Protect the device from damp, dirt and damage during transport, storage and operation.
Only operate the device within the specified technical data limits!
The device should only be operated in an enclosed housing (distribution board)!
The voltage supply to the device must be switched off, before mounting work is performed.
In order to avoid dangerous touch voltages, which originate through feedback from differing phase
conductors, all-pole disconnection must be observed when extending or modifying the electrical
connections.
Manual operation
The device incorporates manual operating features. Special device functions can be undertaken using the
operating keys on the foil keypad.
The foil keypad may not be operated with pointed or sharp-edged objects, e.g. screwdrivers or pens. This
may damage the keypad.
®
KNX Valve Drive Actuator VAA/S x.230.2.1 is a modular installation device for quick
Danger
VAA/S x.230.2.1 | 2CDC 508 101 D0201 11