Parameters - ABB i-bus KNX Product Manual


ABB i-bus KNX
Commissioning
Copy
The following options can be selected before copying the parameter settings:

Leave the group addresses unchanged (if possible) in the target channel

Copy group addresses

Delete group addresses in the target channel
Exchange
The following options can be selected before exchanging the parameter settings:

Retain group addresses

Exchange of group addresses

Deletion of group addresses
3.2

Parameters

Programming of the Valve Drive Actuator is implemented with the Engineering Tool Software (ETS).
The application program is available in the ETS3 at ABB/Heating, Ventilation, Air conditioning/Valve Drive
Actuator.
The following chapter describes the parameters of the device using the parameter window. The parameter
window features a dynamic structure, so that further parameters may be enabled depending on the
parameterization and the function.
The default values of the parameters are underlined, e.g.
Options:
With this button, copy the settings of the source channel into the target channel or
channels.
With this button, exchange the settings of the source channel with the target channel.
Confirm your selection with this button, and the window closes.
Using this button, the window closes without accepting the changes.
yes
no
VAA/S x.230.2.1 | 2CDC 508 101 D0201 23