Commissioning; Overview - ABB i-bus KNX Product Manual


ABB i-bus KNX

Commissioning

3 Commissioning
The ABB i-bus
valve drives for room temperature control. The outputs each feature the same range of functions, whereby
each output can be parameterized individually.
A short overview of all functions of the Valve Drive Actuators can be found in the next chapter.
3.1

Overview

The following table provides an overview of the functions with the Valve Drive Actuators VAA/S x.230.2.1
and their application program:
General
Cyclic monitoring telegram (In operation)
Limit number of sent telegrams
Sending and switching delay after bus voltage recovery
Limit rate of telegrams
Reset error messages for all outputs
Request status values via object
Manual operation
Disable/enable via object
Automatic reset in KNX operation after a time
Manual operating status
Output X General
Error messages (short-circuit/overload)
Reaction on bus voltage recovery
Type of valve drive
Control
- Control value 1 bit (on/off)
- Control value 1 bit (PWM or on/off)
- Status control 1 bit/1 byte
Cyclic monitoring of control value
Output X Functions
Block
Forced operation
Valve purge
- Activate via object
- Adjustable purge duration
- Cyclic purge
- Status valve purge
Characteristic curve correction
Status byte
 = property applies
®
KNX Valve Drive Actuators VAA/S x.230.2.1 are actuators for control of electrothermal
VAA/S 6.230.2.1 VAA/S 12.230.2.1
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
VAA/S x.230.2.1 | 2CDC 508 101 D0201 17
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■