Commissioning; Prerequisites For Commissioning; Commissioning Overview; Putting Device Into Operation - ABB i-bus KNX Product Manual

ABB i-bus® KNX COMMISSIONING
6

Commissioning

6.1

Prerequisites for commissioning

A PC with ETS and a connection to the ABB i-bus® KNX, e.g. via a KNX interface, are required to commis-
sion the device.
• Required ETS version: 5.6 or newer
• Product-specific application installed
6.2

Commissioning overview

After activating the bus voltage for the first time, the following factory settings will be selected auto-
matically:
• Operating mode of outputs: Shutter Actuator (in pairs)
• Switching contact position: open
• Manual operation: enabled
• Physical address of the device: 15.15.255
• ETS application preloaded
Reprogramming can only take place using ETS.
The complete ETS application can be downloaded again if required. Downloads may take longer after
an application is uninstalled or when changing applications.
6.3

Putting device into operation

NOTICE
Damage to the shutter/blind motor
Transport could have changed the relays' contact positions. Undefined contact positions can simulta-
neously energize the Up and Down contacts. The connected shutter/blind motor will be destroyed.
►
NOTICE
The outputs on the device are not interlocked mechanically. The connection of shutter/blind motors to
Switch Actuator outputs will result in damage to the shutter/blind motor.
►
►
1. Connect the device to the ABB i-bus® KNX.
2. Switch on KNX bus voltage.
ð All switching contacts are open.
3. Switch on power supply of the connected loads.
ð Device is ready for operation.
6.4

Assignment of the physical address

The physical address is assigned by ETS.
Note
Switch on KNX bus voltage to establish a defined state of the relays.
Connect shutter/blind motors only to Shutter Actuator output pairs.
Do not drop below the switching/reversing time for the shutter/blind motor connected.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 101