ABB i-bus KNX Product Manual page 179

ABB i-bus® KNX PARAMETERS
7.9.7.1 Parameter setting
This parameter can be used to define whether the settings for the parameter window are adopted from
the template or each parameter is set individually.
Options
Apply from template
Individual
—
7.9.7.1.1
DEPENDENT PARAMETER
Enable group objects "Status Height/Slat"
This parameter can be used to enable the group objects Status Height and Status Slat .
The output sends the relative blind/shutter position and the slat position on two separate group ob-
jects. Each position is sent as a 1-byte value (0 % ... 100 %).
The following applies to the blind/shutter position: The value 0% corresponds to the upper end position;
the value 100% corresponds to the lower end position.
The following applies to slat position: The value 0% corresponds to the open slat position; the value
100% corresponds to the closed slat position.
The group object Status Slat is available only in the Operating mode Blind/shutter control with slat
adjustment .
Options
No
Yes
Condition for visibility:
Parameter window Status messages \ Parameter Parameter setting \ Option Individual
The parameterization is adopted from the template for each parameter.
Parameters can be set individually.
•
•
•
•
•
Note
The group objects will not be enabled.
The group objects will be enabled.
•
Enable group objects "Status Height/Slat"
Enable group objects "Status Upper/Lower end pos."
Enable group object "Status Operability"
Enable group object "Status Automatic sun protection"
Enable group object "Status information"
Send value of group object
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 179