ABB i-bus KNX Product Manual page 156

ABB i-bus® KNX PARAMETERS
Example:
The blind/shutter is in position 50 %. A Down telegram is received. The blind/shutter closes to 60 %.
An Up telegram (=direction change) is received next. Owing to the blind/shutter play during a change
of direction, the blind/shutter will open only to 55% instead of returning to the 50% position.
In order to position the blind/shutter exactly, the blind/shutter play during a change of direction must
be compensated.
This parameter is available only in Operating mode Blind/shutter control without slat adjustment .
Options
0 ... 5,000 ms
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual \ Parameter Set
dead times \ Option Custom
—
7.9.4.1.10
DEPENDENT PARAMETER
Tensioning of the blind/shutter / slot positioning
This parameter can be used to define whether to tension the blind/shutter or position the slots.
More information → Tensioning of the blind/shutter / slot positioning, Page 90.
This parameter is available only in Operating mode Blind/shutter control without slat adjustment .
Options
No
After each down command
Only after reaching lower end
position
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
—
7.9.4.1.10.1
DEPENDENT PARAMETER
Duration for tensioning
This parameter can be used to set the time for which the blind/shutter is to move in the opposite direc-
tion after moving down.
Options
0 ... 5,000 ms
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual \ Parameter Ten-
sioning of the blind/shutter / slot positioning \ Option After each down command
Note
Note
Tensioning/slot positioning is performed after each downward movement.
•
Tensioning/slot positioning is performed only after a downward movement to the lower end posi-
tion.
•
Duration for tensioning
Duration for tensioning
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 156