Functional Overview; Functions Of The Inputs; Functions Of The Outputs - ABB i-bus KNX Product Manual

ABB i-bus® KNX FUNCTION
Pay attention to the service life of the switching contacts when using the function Flashing . Refer to
the Technical data for more information.
Each relay can perform only a limited number of switching operations per minute. A large number of
switching operations per minute can delay switching. Refer to the Technical data for more informa-
tion.
4.2

Functional overview

Type of outputs
Manual operation
Manual operation can be disabled
Staircase lighting
Staircase lighting advance warning
Switching ON/OFF delay
Flashing
NO contact/NC contact
Blind
Shutter
Automatic sun function
Reversing time
Reference movement
Function Scene
Function Threshold
Function Logic
Forced operation/Disable
Safety priorities
Weather alarms
Current detection
Threshold monitoring
Measured value recording
Special functions
Priority during bus voltage failure/recovery
Status message
i-bus® Tool
The interface to i-bus® Tool is not available for Application V1.0. It will be implemented with the next
version.
4.3

Functions of the inputs

This chapter is not relevant for this device.
4.4

Functions of the outputs

A device with 24 channels (A ... X) is described below.
The device outputs can be used individually to switch electrical loads or in pairs to activate 230 V AC
blind and shutter drives. Switch, shutter and blind outputs can be mixed in the device.
Note
Note
Note
Note
SAH/S 8.X.7.1
SAH/S 16.X.7.1
SAH/S 24.X.7.1
Switch Actuator
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 96
Shutter Actuator
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X