ABB i-bus® KNX PARAMETERS
—
7.9.2.1.2.1.2
DEPENDENT PARAMETER
Position height (0 % = top; 100 % = bottom)
This parameter can be used to define the position to which the blind/shutter is moved.
The position will be approached only with deactivated automatic sun protection.
Options
0 ... 100 %
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual \ Parameter Out-
put reacts to \ Option Logic/Threshold x \ Parameter Reaction on result "0" \ Option Individual position
—
7.9.2.1.2.1.3
DEPENDENT PARAMETER
Position slat (0 % = open; 100 % = closed)
This parameter can be used to define the position to which the blind/shutter slats are moved.
The position will be approached only with deactivated automatic sun protection.
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
0 ... 100 %
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual \ Parameter Out-
put reacts to \ Option Logic/Threshold x \ Parameter Reaction on result "0" \ Option Individual position
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 134