ABB i-bus KNX Product Manual page 135

ABB i-bus® KNX PARAMETERS
—
7.9.2.1.2.2
DEPENDENT PARAMETER
Reaction on result "1"
This parameter can be used to define how the blind/shutter reacts when the result of the Logic or
Threshold function is 1.
Options
No reaction
Up
Down
Stop
Unchanged (disable)
Scene assignment
Individual position
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual \ Parameter Out-
put reacts to \ Option Logic/Threshold x
—
7.9.2.1.2.2.1
DEPENDENT PARAMETER
Scene assignment
This parameter can be used to define which scene number is retrieved.
The scene assignment must be defined in Parameter window Scene assignments, in the parameter En-
able scene assignment x.
Options
1 ... 16
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual \ Parameter Out-
put reacts to \ Option Logic/Threshold x \ Parameter Reaction on result "1" \ Option Scene assignment
If the blind/shutter is moving, it will continue until reaching the target position. If the blind/shutter is
at rest, its position will remain unchanged.
The blind/shutter moves to the upper end position
The blind/shutter moves to the lower end position
If the blind/shutter is moving, it will be stopped. If the blind/shutter is at rest, its position will remain
unchanged.
If the blind/shutter is moving, it will continue until reaching the target position. If the blind/shutter is
at rest, its position will remain unchanged. The blind/shutter is then disabled in this position.
The scene assigned to the Shutter Actuator output pair is performed.
•
The required positions of the blind/shutter and slats (depending on operating mode) can be defined.
•
•
Note
Scene assignment
Position height (0 % = top; 100 % = bottom)
Position slat (0 % = open; 100 % = closed)
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 135