ABB i-bus KNX Product Manual page 154

ABB i-bus® KNX PARAMETERS
—
7.9.4.1.9
DEPENDENT PARAMETER
Set dead times
This parameter can be used to define whether the default dead times or user-defined dead times are to
be used.
More information → Dead times, Page 89.
Incorrect settings in the parameters can cause malfunctions. Pay attention to technical data for the
connected drive when changing these parameters.
Options
Default
Custom
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
—
7.9.4.1.9.1
DEPENDENT PARAMETER
Dead time blind/shutter from bottom until moving up
This parameter can be used to set the dead time that the blind/shutter requires between a movement
telegram and the first upward movement.
Example:
The slatted curtain is in the lower end position (= 100% down). An Up telegram is received. The motor
shaft starts turning. However, the slatted curtain remains unchanged in its lower end position and be-
gins to move up again only after the dead time elapses.
Options
0 ... 5,000 ms
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual \ Parameter Set
dead times \ Option Custom
—
7.9.4.1.9.2
DEPENDENT PARAMETER
Dead time of slat from 100 % closed until slat turn
This parameter can be used to set the dead time that is required for a slat adjustment from fully closed
(100%) to the first adjustment of the slat after receipt of a telegram for slat adjustment.
Note
•
•
•
•
The values can be set individually.
•
•
•
•
The following values are used:
Blind/shutter dead time: 0 ms
Slat dead time: 0 ms
Slippage of blind/shutter on change of direction: 0 ms
Dead time blind/shutter from bottom until moving up
Dead time of slat from 100 % closed until slat turn
Slippage of slat on change of direction
Slippage of blind/shutter on change of direction
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 154