ABB i-bus KNX Product Manual page 194

ABB i-bus® KNX PARAMETERS
—
7.10.2.1.4
DEPENDENT PARAMETER
Feedback of switching state via group object "Status switch"
This parameter can be used to define whether the relay contact position is signaled via the group object
Status Switch .
Options
No
Yes
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual
—
7.10.2.1.4.1
DEPENDENT PARAMETER
Value of group object "Status switch"
This parameter can be used to define the value that the group object Status Switch assumes depending
on the relay switching state. This can serve to invert the value of the group object.
Options
1: closed, 0: open
0: closed, 1: open
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual \ Parameter Feed-
back of switching state via group object "Status switch" \ Option Yes
—
7.10.2.1.4.2
DEPENDENT PARAMETER
Send value of group object
This parameter can be used to define whether the value of the group object will be sent to the
ABB i-bus® KNX.
Options
No, update only
After change
On request
After change or on request
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual \ Parameter Feed-
back of switching state via group object "Status switch" \ Option Yes
The group object Status Switch is not enabled.
The group object Status Switch is enabled.
• Value of group object "Status switch"
• Send value of group object
The group object has the value 1 when the relay contact is closed.
The group object has the value 0 when the relay contact is open.
The group object has the value 0 when the relay contact is closed.
The group object has the value 1 when the relay contact is open.
The value of the group object is updated but not sent.
The value of the group object is sent after every change.
The value of the group object is sent on request. A request can be triggered by sending the value 0 or
1 on the group object Request status values .
The value of the group object is sent after a change or on request. A request can be triggered by
sending the value 0 or 1 on the group object Request status values .
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 194