ABB i-bus KNX Product Manual page 211

ABB i-bus® KNX PARAMETERS
7.10.6.1 Parameter setting
This parameter can be used to define whether the settings for the parameter window are adopted from
the template or each parameter is set individually.
Options
Apply from template
Individual
—
7.10.6.1.1
DEPENDENT PARAMETER
Flashing if group object Flashing equals
This parameter can be used to define the telegram value on the group object Flashing at which the
Flashing function is activated.
Options
ON (1) or OFF (0)
ON (1)
OFF (0)
Condition for visibility:
Parameter window Flashing \ Parameter Parameter setting \ Option Individual
—
7.10.6.1.2
DEPENDENT PARAMETER
Time for ON
This parameter can be used to define how long the output is switched on during an On/Off change.
Options
00:00:01 ... 00:00:05 ... 18:12:15 hh:mm:ss
Condition for visibility:
Parameter window Flashing \ Parameter Parameter setting \ Option Individual
—
7.10.6.1.3
DEPENDENT PARAMETER
Time for OFF
This parameter can be used to define how long the output is switched off during an On/Off change.
Options
00:00:01 ... 00:00:05 ... 18:12:15 hh:mm:ss
Condition for visibility:
Parameter window Flashing \ Parameter Parameter setting \ Option Individual
The parameterization is adopted from the template for each parameter.
Parameters can be set individually.
• Flashing if group object Flashing equals
• Time for ON
• Time for OFF
• Number of flashing cycles
• Contact position after flashing
A telegram with the value 1 or 0 triggers flashing. Flashing cannot be ended prematurely.
A telegram with the value 1 triggers flashing. A telegram with the value 0 ends flashing.
A telegram with the value 0 triggers flashing. A telegram with the value 1 ends flashing.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 211