ABB i-bus KNX Product Manual page 139

ABB i-bus® KNX PARAMETERS
7.9.3 Parameter window Drive
The following settings can be made in the Parameter window Drive:
• Setting the blind/shutter travel time
• Trigger reference movement
• Setting reversing time for drive
• Setting delay time for drive
More information → Drive settings, Page 86.
If several Shutter Actuator output pairs are to be set to the same values, parameterization can be per-
formed in Parameter window Shutter Actuator template.
Fig. 41: Parameter window Drive
Parameter
• Parameter setting
• Travel time up
• Travel time down
• Disconnect output from power after
• Enable group object "Trigger reference movement"
• Reversing time
• Delay time for drive
Note
• Position after reference movement
• Start-up delay
• Coasting delay
• Minimum run time for drive
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 139