ABB i-bus KNX Product Manual page 210

ABB i-bus® KNX PARAMETERS
7.10.6 Parameter window Flashing
This parameter window is visible only if, in the Parameter window Functions, the following option is
set for the parameter Enable function Time: Flashing .
The following settings can be made in the Parameter window Flashing:
• Duration and reaction of the Flashing function
More information → Function Flashing, Page 95.
If several Shutter Actuator outputs are to be set to the same values, parameterization can be per-
formed in Parameter window Switch Actuator template.
Each relay can perform only a limited number of switching operations per minute. A large number of
switching operations per minute can delay switching. Refer to the Technical data for more informa-
tion.
Pay attention to the service life of the switching contacts when using the function Flashing . Refer to
the Technical data for more information.
Fig. 52: Parameter window Flashing
Parameter
• Parameter setting
• Flashing if group object Flashing equals
• Time for ON
• Time for OFF
• Number of flashing cycles
• Contact position after flashing
Note
Note
Note
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 210