ABB i-bus KNX Product Manual page 132

ABB i-bus® KNX PARAMETERS
7.9.2.1 Parameter setting
This parameter can be used to define whether the settings for the parameter window are adopted from
the template or each parameter is set individually.
Options
Apply from template
Individual
—
7.9.2.1.1
DEPENDENT PARAMETER
Output reacts to central shutter group objects
This parameter can be used to define whether the Shutter Actuator output pair can be switched via the
central Shutter group objects.
This parameter is visible only if, in the Parameter window Device settings, the following option was set
for the parameter Enable central Shutter group objects: Yes .
Options
No
Yes
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual
—
7.9.2.1.2
DEPENDENT PARAMETER
Output reacts to
This parameter can be used to define whether the output is influenced by the result of a Logic or
Threshold function.
More information → Function Logic, Page 84, → Function Threshold, Page 85.
Options
No Logic/Threshold function
Logic/Threshold x
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual
The parameterization is adopted from the template for each parameter.
Parameters can be set individually.
•
•
•
•
•
Note
The output does not react to a Logic or Threshold function.
The output reacts to the Logic or Threshold function x (x = 1 ... 24).
•
•
Output reacts to central shutter group objects
Output reacts to
Reaction on bus voltage failure
Reaction after bus voltage recovery
Reaction after ETS download
Reaction on result "0"
Reaction on result "1"
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 132