Software/Application; Download Reaction; Copying, Exchanging And Converting - ABB i-bus KNX Product Manual

ABB i-bus® KNX COMMISSIONING
Press Programming button.
►
ð Programming LED lights up.
ð If the physical address is assigned, the LED goes out.
Pressing the Programming button again cancels the programming process. The physical address is
saved. The LED goes off.
The device performs an ETS reset during physical address assignment. All states are reset.
6.5

Software/application

The interface to i-bus® Tool is not available for Application V1.0. It will be implemented with the next
version.
6.5.1

Download reaction

Using an interface that supports "long frames" (e.g. USB/S 1.2 or IPR/S 3.5.1) can significantly shorten
the download time.
Depending on the PC used, it may take up to 90 seconds after a download is started for the progress bar
to appear.
6.5.2

Copying, exchanging and converting

The ETS app ABB Update Copy Convert ETS can be used to copy/exchange parameter settings and con-
vert the application version. The ETS app is available free of charge from the KNX online shop.
The following functions are available in the ETS app:
• Update : Changes the application program to a later or earlier version while retaining current configu-
rations
• Convert : Transfers/adopts a configuration from an identical or compatible source device
• Copy channel : Copies a channel configuration to other channels on a multichannel device
• Channel Exchange : exchanges configurations between two channels on a multichannel device
• Import/Export : Saves and reads device configurations as external files
Note
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 102