ABB i-bus KNX Product Manual page 168

ABB i-bus® KNX PARAMETERS
—
7.9.5.1.5.2
DEPENDENT PARAMETER
Position slat (0 % = open; 100 % = closed)
This parameter can be used to define the position to which the blind/shutter slats are moved.
The position will be approached only with deactivated automatic sun protection.
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
0 ... 100 %
Condition for visibility:
Parameter window Safety/Weather \ Parameter Parameter setting \ Option Individual \ Parameter
Forced operation (1 bit / 2 bit) \ Option Activated 1 bit – 0 active
—
7.9.5.1.5.3
DEPENDENT PARAMETER
Forced operation active ON
The parameters Position height (0 % = top; 100 % = bottom) and Position slat (0 % = open; 100 % =
closed) can be used to define the position of the blind/shutter and the slats if 2-bit forced operation is
in the Active ON state.
Condition for visibility:
Parameter window Safety/Weather \ Parameter Parameter setting \ Option Individual \ Parameter
Forced operation (1 bit / 2 bit) \ Option Activated 2 bit
—
7.9.5.1.5.4
DEPENDENT PARAMETER
Forced operation active OFF
The parameters Position height (0 % = top; 100 % = bottom) and Position slat (0 % = open; 100 % =
closed) can be used to define the position of the blind/shutter and the slats if 2-bit forced operation is
in the Active OFF state.
Condition for visibility:
Parameter window Safety/Weather \ Parameter Parameter setting \ Option Individual \ Parameter
Forced operation (1 bit / 2 bit) \ Option Activated 2 bit
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 168