ABB i-bus KNX Product Manual page 120

ABB i-bus® KNX PARAMETERS
—
7.6.1.4
DEPENDENT PARAMETER
Send result on KNX
This parameter can be used to define whether the result of the function Logic will be written to the
group object Result .
Options
No
Yes
Condition for visibility:
Parameter window Logic/Threshold 1 \ Parameter Function of the logic gate \ Option AND
—
7.6.1.4.1
DEPENDENT PARAMETER
Send value of group object
This parameter can be used to define whether the value of the group object will be sent to the
ABB i-bus® KNX.
Options
No, update only
After change
On request
After change or on request
Condition for visibility:
Parameter window Logic/Threshold 1 \ Parameter Function of the logic gate \ Option AND \ Parameter
Send result on KNX \ Option Yes
—
7.6.1.5
DEPENDENT PARAMETER
GATE disables if group object "Connection A" equals
This parameter can be used to define the value on the group object Connection A at which the GATE will
be disabled. If the GATE is disabled, telegrams received on the group object Connection B are ignored.
Options
1
0
Condition for visibility:
Parameter window Logic/Threshold 1 \ Parameter Function of the logic gate \ Option GATE
The result is not output on the ABB i-bus® KNX.
The result is output on the ABB i-bus® KNX. The group object Result is enabled. The group object
sending behavior can be defined in the parameter Send value of group object.
• Send value of group object
The value of the group object is updated but not sent.
The value of the group object is sent after every change.
The value of the group object is sent on request. A request can be triggered by sending the value 0 or
1 on the group object Request status values .
The value of the group object is sent after a change or on request. A request can be triggered by
sending the value 0 or 1 on the group object Request status values .
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 120