ABB i-bus KNX Product Manual page 103

ABB i-bus® KNX PARAMETERS
7 Parameters
7.1 General
ETS (Engineering Tool Software) is used to parameterize the device.
The following chapters describe the device parameters based on the parameter windows. The parame-
ter windows have a dynamic design. Parameters are shown or hidden depending on the outputs' param-
eterization and function.
The default values of the parameters are underlined, e.g.:
No (checkbox cleared)
Yes (checkbox ticked)
The screenshots show an application for devices with manual operation.
A device with 24 channels (A ... X) is described below.
Note
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 103