ABB i-bus KNX Product Manual page 107

ABB i-bus® KNX PARAMETERS
7.3 Parameter window Device settings
The following settings can be made in the Parameter window Device settings:
• Setting sending and switching delay
• Activate i-bus® Tool access
• Enable group object Request status values
• Enable central group objects
Fig. 35: Parameter window Device settings
Parameter
• Sending and switching delay after bus voltage recovery
• State after sending and switching delay has expired
• i-bus® Tool access
• Enable group object "Request status values"
• Enable central Switch group object
• Enable central Shutter group objects
• Enable central Scene group object
• Enable group object "In operation"
• Sending cycle
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 107