ABB i-bus KNX Product Manual page 192

ABB i-bus® KNX PARAMETERS
7.10.2.1 Parameter setting
This parameter can be used to define whether the settings for the parameter window are adopted from
the template or each parameter is set individually.
Options
Apply from template
Individual
—
7.10.2.1.1
DEPENDENT PARAMETER
Reaction of output
This parameter can be used to set how the output reacts on receipt of a switching telegram on the
group object Switch .
Options
NC contact
NO contact
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual
—
7.10.2.1.2
DEPENDENT PARAMETER
Switch output reacts to central Switch group object
This parameter can be used to define whether the output can be switched via the central group object
Switch
This parameter is visible only if, in the Parameter window Device settings, the following option was set
for the parameter Enable central Switch group object: Yes .
Options
No
Yes
Condition for visibility:
Parameter window Basic settings \ Parameter Parameter setting \ Option Individual
The parameterization is adopted from the template for each parameter.
Parameters can be set individually.
•
•
•
•
•
•
•
•
The contact is opened with an On telegram (1) and closed with an Off telegram (0).
The contact is closed with an On telegram (1) and opened with an Off telegram (0).
Note
Reaction of output
Switch output reacts to central Switch group object
Output reacts to
Feedback of switching state via group object "Status switch"
Enable group object "Status information"
Reaction on bus voltage failure
Reaction after bus voltage recovery
Reaction after ETS download
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 192