ABB i-bus KNX Product Manual page 197

ABB i-bus® KNX PARAMETERS
7.10.3 Parameter window Safety
This parameter window is visible only if, in the Parameter window Functions, the following option is
set for the parameter Enable function Safety: Yes .
The following settings can be made in the Parameter window Safety:
• Reaction to safety priorities
• Reaction on Disable and Forced operation functions
• Switching state after cancellation of the Disable and Forced operation functions and safety priorities
The order of priority of safety functions is as shown in the parameter window and cannot be changed:
a)
b)
c)
d)
e)
More information → Switch Actuator safety functions, Page 80.
If several Shutter Actuator outputs are to be set to the same values, parameterization can be per-
formed in Parameter window Switch Actuator template.
Fig. 49: Parameter window Safety
Parameter
• Parameter setting
• Switching status for safety priority x
• Forced operation (1 bit / 2 bit)
• Disable
• Switching state on cancellation of disabling, forced operation and safety priority
Note
Safety priority 1
Forced operation
Safety priority 2
Safety priority 3
Disable
Note
• Switching status during forced operation
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 197