ABB i-bus KNX Product Manual page 200

ABB i-bus® KNX PARAMETERS
—
7.10.3.1.3
DEPENDENT PARAMETER
Disable
This parameter can be used to enable the group object Disable and define the relay switching position
when the value 1 is received on the group object Disable .
As long as disabling is active, the relay switching position cannot be changed via group objects, man-
ual operation or the i-bus® Tool.
Higher-priority safety functions will continue to run.
Options
No reaction
ON
OFF
Unchanged (disable)
Condition for visibility:
Parameter window Safety \ Parameter Parameter setting \ Option Individual
—
7.10.3.1.4
DEPENDENT PARAMETER
Switching state on cancellation of disabling, forced operation and safety priority
This parameter can be used to define the switching position that the relay assumes after cancellation of
a safety priority or the Disable or Forced operation function.
Options
No reaction
ON
OFF
Refreshed KNX state
Condition for visibility:
Parameter window Safety \ Parameter Parameter setting \ Option Individual
Note
The function Disable is not used.
The group object Disable is enabled. The relay is disabled in switching position On when the value 1 is
received.
The group object Disable is enabled. The relay is disabled in switching position Off when the value 1
is received.
The group object Disable is enabled. The relay is disabled when the value 1 is received. The switching
position is not changed.
The relay switching position remains unchanged.
The relay switching position is On.
The relay switching position is Off.
The refreshed KNX state is used. More information → Refreshed KNX state, Page 83.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 200