ABB i-bus KNX Product Manual page 181

ABB i-bus® KNX PARAMETERS
—
7.9.7.1.2.1
DEPENDENT PARAMETER
Send value of group object
This parameter can be used to define whether the value of the group object will be sent to the
ABB i-bus® KNX.
Options
No, update only
After change
On request
After change or on request
Condition for visibility:
Parameter window Status messages \ Parameter Parameter setting \ Option Individual \ Parameter En-
able group objects "Status Upper/Lower end pos." \ Option Yes
—
7.9.7.1.3
DEPENDENT PARAMETER
Enable group object "Status Operability"
This parameter can be used to enable the group object Status Operability . This group object indicates
whether KNX operation of the output is enabled or disabled.
KNX operation is disabled under the following conditions:
• Safety functions active (weather alarm, disabling or forced operation)
• Operating mode Manual operation active
• KNX operation is disabled via group objects (Disable automatic sun protection and
Disable direct operation )
This group object can be used to have an LED on the button indicate to the user that operation of the
output is not possible using this button and that automatic control cannot be activated either.
Options
No
Yes
Condition for visibility:
Parameter window Status messages \ Parameter Parameter setting \ Option Individual
The value of the group object is updated but not sent.
The value of the group object is sent after every change.
The value of the group object is sent on request. A request can be triggered by sending the value 0 or
1 on the group object Request status values .
The value of the group object is sent after a change or on request. A request can be triggered by
sending the value 0 or 1 on the group object Request status values .
The group object is not enabled.
The group object is enabled.
• Send value of group object
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 181