ABB i-bus KNX Product Manual page 117

ABB i-bus® KNX PARAMETERS
7.6 Parameter window Logic/Threshold 1
The parameter windows and the structure of the parameters are identical for all Logic/Threshold func-
tions. Therefore, only one parameter window will be described below by way of example.
This parameter window is visible only if, in the Parameter window Configuration, the following option
is set for the parameter Enable Logic/Threshold X-Y: Yes .
The Parameter window Logic/Threshold 1 can be used to make all settings for the Logic/Threshold func-
tions.
The Logic/Threshold functions can be used independently of the other device functions. The result of
the Logic/Threshold function can be internally linked with any output and/or sent on the
ABB i-bus® KNX.
More information → Function Logic, Page 84, → Function Threshold, Page 85.
Fig. 38: Parameter window Logic/Threshold 1
Parameter
• Function of the logic gate
• Group object "Connection A" after bus voltage recovery
• Group object "Connection B" after bus voltage recovery
• Invert result
• Send result on KNX
• GATE disables if group object "Connection A" equals
• Data type of group object "Threshold input"
• Upper threshold
• Lower threshold
• Change thresholds via KNX
• Result if upper threshold is exceeded
• Min. duration of the overshoot
• Result if the input value is between the thresholds
• Minimum dwell time between the thresholds
• Result if lower threshold is dropped below
• Min. duration of the undershoot
• Update result after each overshoot/undershoot
• Send result on KNX
Note
Note
• Send value of group object
• Send value of group object
• Send value of group object
• Send value of group object
• Send value of group object
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 117